On TOP LOAD WASHING MACHINES be sure the pulley on the transmission turns in the spin and agitate positions.Ĭheck that there is nothing hindering the agitator or wash basket movement. If the belt is in good condition be sure you check that the idler pulley and or glide on the motor is working correctly and is able to move as designed. When your washer is not spinning, check the drive belt for damage, rips, over stretched, or has fallen off. In most FRONT LOAD WASHING MACHINES the drive motor connects to the wash basket. In most TOP LOAD WASHING MACHINES the washer drive belt connects the drive motor to the washer transmission. “Washer Drive Belt / Spin Belt on Front and Top Load Washers” Or type in your washing machine model number and company manufacturer into Google and do a check for “Washing Machine Remove Replace WLC Pressure Switch Model# Serial#”. To replace this switch, the proper procedure for removing the switch will vary by different washing machine models so look in the user’s manual guide that came with your washer for the proper removal procedure. If the switch is visibly cracked or burned you will need to replace it. If the tube is clogged with soapy residue, then you can try forcing vinegar down the tube and in the switch itself by using a turkey baster as this will dissolve the soapy residue. Once identified, pull the plastic hose off the water level switch and blow air into it. To identify it look for the part with the small plastic tube attached to it. Once removed you will see the Water Level Control Valve. You can check this yourself by removing the 4 screws that hold the control panel in place. This is usually always the defective part when your washing machine pumps the water out but will not spinand also when the water overflows on your washer. If the lid switch is functioning properly, go to the next step.Īnother common item to go bad in your washer is the “Water Level Control / Pressure Switch”. If the switch does not have continuity when pressed in, the lid switch needs to be replaced. When the lid is OPEN (button not pressed in), the switch should have no continuity. When you have the lid CLOSED (button pressed in), the switch should have continuity. Press the button on the switch to simulate closing the lid. Once the switch is removed keep the wires coming from the washer attached to it so you can test it with a digital multimeter. Remember to unplug your washer before you begin any testing or repairs. Or type in your washing machine’s model number and company manufacturer into Google and do a check for “Washing Machine Remove Lid Switch Model# Serial#”. The proper procedure for removing the switch will vary by different washing machine models so look in the user’s manual guide that came with your washer for the proper removal procedure. (The lid switch is inside the washing machine main housing near the door frame.) To properly check this you must remove the lid switch. However on some washing machine models it will still agitate but not spin. Top loading washing machines that have a faulty lid switch will not turn the agitator and the spin cycle will not start. There may be an issue with the “Lid Switch”. To fix your washer yourself, you may need to find your Washing Machine Service Repair manual. This should be completed before taking off parts or removing panels to make sure the computer control is not at fault. The absolute first thing to do to your washing machine that will not spin or drain (whether it is top loading or front loading) is to perform a “Master Reset” to the washer. How do you fix a washer that will will not spin or drain? If your old or new washing machine does not spin we have some diy fix tips below to get it running again.
0 Comments
Leave a Reply. |